French Drains Proper Drainage Solution Regrade Property

Drainage Solution : How to Regrade

Establish the drainage slope. The yard around your house should slant away from the house at a minimum slope 3/4 inch per ft for at least 10 ft . Till the soil or add new soil around the house perimeter. Drive a wood stake next to the house and another 10 ft out. Tie a level mason’s string between the stakes, and then move the string down at least 2 1/2 inches at the end away from the house , establishing your minimum slope.

Redistribute the soil with a steel garden rake so the grade follows the slope line. Add top soil at the high end if needed. Do not excavate bear the end of the slope accommodate the grade. The goal is to build up the yard to create runoff.

Use a grading rake to smooth out the soil so it slopes at an even rate . Drive additional stakes and tie off slope lines as necessary.

Tamp the soil with a hard tamper or plate compactor . Fill in any dips that occur with fresh dirt . Lay sod or plant grass or cover immediately.

Drainage solution : How to install a dry well

A dry well is a simple way to channel excess water out low lying or water laden areas , such as the ground beneath a gutter downspout . Dry well system typically consists of a buried drain tile running from a catch basin positioned at the problem spot to a collection container some distance away .

A dry well system is easy to install and surprisingly inexpensive . In the project shown here, a perforated plastic drain tile carries water from a plastic trash ca that has been punctured , then filled with stone rubble. The run off water percolates into the soil as it makes its way along the drain pipe and through the dry well.

The how to steps of this project include digging the trench with a shovel . If the catch basin is a long distance from the from the problem area, you may want to rent a trencher to dig the trench quickly. Call local utility companies to mark the location of underground mechanics before you start to dig .

Set a length of perforated drain tile on the gravel running the full length of the trench. If the trench starts at a downspouts , position a grated catch basin directly beneath the downspout and attach the end of the drain tile to the outlet port .

Dig a trench ( 10 inches , 14 inches deep) from the area where the water collects to the catch basin location , sloping the trench 2 inch per 8 foot . Line the trench with landscape fabric add 1 inch layer of gravel on top of the fabric .

Install the dry well by digging a hole that’s big enough to hold a plastic trash can . Drill 1 inch holes through the sides and bottom of the can every 4 inches to 6 inches . Also cut an access hole at the top of the can for the drain tile . Set the can in the hole and insert the free end of the tile . Backfill dirt over the tile and trench and plant grass or cover with sod.