Gutters Installing

Installing a snap together vinyl gutted is a manageable task for most do it yourselfers. Snap together gutter systems are designed for ease of installation , requiring no fasteners other than the screws used to attach the gutter hangers to the fascia .

Tool & Materials
Chalk Line , Tape Measure , Drill , Hacksaw, 1 1/4 inch deck screws , Gutters, Drain pipes, Connectors , Fittings , Hangers , Protective equipment.

Estimating Gutter Parts
Gutter sections : Measure total length of run ; 15 percent for waste , Sold in 10 foot length.
Inside/out corners : one per corner no outlet.

Connectors : Two per corner ; one per end .
End caps right and left per end .
Downspouts outlets: One for every 35 foot of gutter .
Down spout elbow : Three per downspout.
Drainpipe : one pipe per downspout outlet . Measure gutter height and add 5 foot for each pipe for splash block outlet and waste.
Drainpipe hangers : Two per drainpipe.

How to install Vinyl Gutters

Mark a point the high and each of each gutter , 1 inch from the top the fascia . Snap chalk lines that slope 1/4 inch per 10 feet. toward downspouts. For runs longer than 35 feet mark a slope from a high point in the center toward down spouts at each end .

Install downspout outlets near the ends of gutter runs at least one outlet for every 35 feet of run. The tops of the outlets should be flush with the slope line, and they should align with ends caps on the corners of the house

Following the slope line , attach hangers or support clips for hangers for a complete run . Attach them to the fascia at 24 inches intervals using deck screws .

Following the slope line attach outside and inside corners at all corner locations that do not have end caps.

Use a hacksaw to cut gutter sections to fit between outlets and corners . Attach the end cpas and connect gutter sections to the outlets. Cut and test fit gutter sections to fit between outlets, allowing for expansion .

Working on the ground, join the gutter sections together using connectors . Attach gutter hangers to the gutter for models with support clips mounted on the fascia . Hang the gutters, connecting them to the outlets.

Cut a section of drainpipe to fit between two downspout elbows, One elbow should fit over the tail of the downspout outlet and the other should fit against the wall. Assemble the parts, slip the top elbow onto the outlet . and secure the other to the siding with a drainpipe hanger.

Cut a piece to fit between the elbow at the top of the wall and the end of the drainpipe run, staying at least 12 inches above the ground . Attach an elbow ,and secure the pipe to the wall with a drainpipe hanger . Add accessories , such as splash blocks , to help channel water away from the house .